Some users may find that the colored switch cap comes off too easily while using the Big Beamer transmitter. This article will describe how to secure it so it remains firmly in place.

Required Items🔗

• Big Beamer Transmitter
• A semi-permanent adhesive such as:
  • Elmer’s School Glue
  • Hot glue from a hot glue crafting gun
  • Thread seal tape (otherwise known as plumber’s tape)
  • Removable mounting or poster putty

Instructions🔗

To better secure your switch top to the body of your Big Beamer, we recommend adding a small amount of semi-permanent adhesive to the threads of the switch top. This will provide additional resistance to help hold the switch top in place. To do this, follow these steps:

1. Select an adhesive from the list above.
2. Remove the colored switch top from the Big Beamer by twisting counterclockwise.
3. Ensure that the switch cap and the mounting area on your Big Beamer are clean and dry.
4. Add the semi-permanent adhesive to the threads on the device.
   • If using glue or putty, apply a small amount directly to the mounting surface of the switch cap.
   • If using thread seal tape, wrap a thin layer of tape around the mounting area.
5. Replace the colored switch top of your choice back onto the device by twisting clockwise.
6. If using glue, allow sufficient drying time as recommended by the manufacturer before using your device.

Tips and Troubleshooting🔗

• If the switch cap still feels loose, try applying an additional adhesive layer or tape for extra grip.
• Avoid using permanent adhesives, as they may make future removal difficult or damage the device.
• If you need to remove the switch cap later, gently twist and pull it off. If necessary, use warm water to loosen glue-based adhesives.

For additional support, visit the Big Beamer Transmitter Support Hub. If you have further questions, please contact the ableCARE Product Success Team.