Introduction🔗

The video below offers an introduction and overview of how to use the Jelly Beamer Transmitter. It will guide you through initial setup, including batteries and pairing. Please note that you will need a Wireless Receiver to use this product.

Additional Resource Links🔗

• Jelly Beamer Quick Start Guide
• Jelly Beamer Instructions for Use

• Wireless Receiver Quick Start Guide
• Wireless Receiver Instructions for Use

• Blank Overlays
• AT Resource Hub for activities and curriculum featuring this device

Tips and Troubleshooting🔗

Pairing🔗

The video below demonstrates how to pair the Jelly Beamer with the Wireless Receiver.

To connect the Original Wireless Receiver to a Jelly Beamer, follow the steps below:

1. Insert new batteries into the Jelly Beamer and Wireless Receiver.
2. Turn ON both the Jelly Beamer and Wireless Receiver
3. Press and hold the Test button on the Wireless Receiver until the LED turns green (about 5 seconds).
4. Press the switch on top of the Jelly Beamer to link it to the receiver.
   • NOTE: you can repeat this step for additional transmitters (up to 8 transmitters can be paired to a single receiver).
5. Press the Test button once on the Wireless Receiver to exit pairing mode.

Batteries🔗

We recommend always using regular, alkaline batteries to avoid any issues with your device. If your device is not working correctly, it may be due to one of two battery issues:

• Low or Depleted Batteries: The batteries in your device may need to be replaced.
• Battery Type Issues: If you’re using rechargeable batteries or batteries labeled “Heavy Duty,” “Industrial Grade,” or “ProCell,” these types may cause the device to behave as if the batteries are low or dead. These battery types manage power differently from regular alkaline batteries and are not recommended for use with this product.

How to resolve:

• Replace the batteries with new, regular alkaline batteries.
• Make sure the replacement batteries are fresh and recently purchased. Used batteries or batteries that have been sitting unused for some time may not have enough power to operate your device properly.

Please visit the Jelly Beamer Support Hub for additional support resources.