Introduction🔗

The video below offers an introduction and overview of how to use the All-Turn-It Spinner. Here are the topics covered and their video timestamps:

0:20 Batteries
0:53 Adding an overlay
1:28 Spinning the arrow and small overlay

Advanced Features🔗

The video demonstrates how to use wireless switch control with the All-Turn-It spinner. Please note that this requires the Wireless Receiver and a Jelly Beamer or a Big Beamer Transmitter switch, which are sold separately.

Additional Resource Links🔗

• All-Turn-It Spinner Quick Start Guide
• All-Turn-It Spinner Instructions for Use
• All-Turn-It Spinner Overlay Directions
• AT Resource Hub for activities and curriculum featuring this device

Tips and Troubleshooting🔗

Installation🔗

To install the center disk, spinner, and clear plastic cover, please review these steps or view the animated GIF to watch this process.

1. Push down firmly with two fingers on the center disk, press close to the spindle to ensure that the disk is firmly in place.
2. Next, put the spinner on the spindle and press down gently.
3. Then, place the clear plastic over so that the tabs line up with the grooves.
4. Finally, twist the plastic clockwise a quarter turn until it clicks into place.

My All-Turn-It Spinner Isn’t Spinning🔗

We recommend trying the following options to resolve this issue, after trying each fix test it by pressing the red button.

• Make sure the clear plexiglass cover is locked into place.
  • To do this, align the clear plexiglass cover in the center of the device and rotate it ¼ turn (clockwise) until it clicks into place. This will engage the internal safety switch, letting the device operate correctly.
• Secure the inner overlay.
  • To ensure that the inner overlay is properly seated, press down on it at the point where it attaches to the center post. You should feel and hear a “click” when it is securely in place.
• Test your batteries.
  • Low or Depleted Batteries: The batteries in your device may need to be replaced.
  • Battery Type Issues: If you’re using rechargeable batteries or batteries labeled “Heavy Duty,” “Industrial Grade,” or “ProCell,” these types may cause the device to behave as if the batteries are low or dead. These battery types manage power differently from regular alkaline batteries and are not recommended for use with this product.
  • Replace the batteries with new, regular alkaline batteries.
  • Make sure the replacement batteries are fresh and recently purchased. Batteries used in other devices or sitting unused for some time may not have enough power to operate your device properly.

Why Doesn’t My All-Turn-It-Spinner Spin With Every Press of the Button? 🔗

The All-Turn-It Spinner has a built-in delay to prevent it from spinning every time the button is pressed. The spinner will not spin until it has been 8 seconds since the last press.

Additional Resources🔗

Please visit the All-Turn-It Spinner Support Hub for additional support resources.