Introduction

The video below offers an introduction and overview of how to use the Big Beamer Transmitter. It will guide you through the initial setup, including batteries and pairing.

Additional Resource Links

• Big Beamer Quick Start Guide
• Wireless Receiver Quick Start Guide
• Big Beamer Instructions for Use
• Wireless Receiver Instructions for Use
• Blank Overlays

Tips and Troubleshooting

Pairing

The video below demonstrates how to pair the Jelly Beamer with the Wireless Receiver. The same steps can be used to pair the Big Beamer.

To connect the Original Wireless Receiver to a Jelly Beamer or Big Beamer Transmitter, follow the steps below:

1. Insert new batteries into the Transmitter and Original Receiver.
2. Turn ON both the Transmitter and Original Receiver
3. Enter pairing mode by pressing and holding the Test button on the Original Receiver for about 5 seconds or until the LED turns green.
4. Press the switch on top of the Transmitter to link it to the receiver. Please note that you may repeat this step for additional transmitters (up to 8 transmitters can be paired to a single receiver).
5. Exit pairing mode by pressing the pairing button on the Original Receiver once.

Batteries

We recommend always using regular, alkaline batteries to avoid any issues with your device. If your device is not working correctly, it may be due to one of two battery issues:

1. Low or Depleted Batteries: The batteries in your device may need to be replaced.
2. Battery Type Issues: If you’re using rechargeable batteries or batteries labeled “Heavy Duty,” “Industrial Grade,” or “ProCell,” these types may cause the device to behave as if the batteries are low or dead. These battery types manage power differently from regular alkaline batteries and are not recommended for use with this product.

How to resolve:

• Replace the batteries with new, regular alkaline batteries.
• Make sure the replacement batteries are fresh and recently purchased. Batteries that have been used in other devices or have been sitting unused for some time may not have enough power to operate your device properly.

Please visit the Big Beamer Support Hub for additional support resources. If you have any additional questions, please contact the ableCARE Product Success Team for further assistance.

Don’t Forget to Register Your Product

Registering your product provides you access to ableCARE, product updates, and resources for your product. Click here to visit our product registration page to get started.